Texas Instruments DLP5534PROJQ1EVM, Руководство пользователя, Страница: 10 / 13

Quick Start
www.ti.com
10 DLPU097 – November 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
DLP5534PROJQ1EVM Evaluation Module User's Guide
2 Quick Start
Use the following instructions to setup your DLP5534PROJQ1 EVM and PC.
2.1 Kit Assembly Instructions
A diagram of all the EVM cable connections is shown in Figure 5 .
1. Connect the Micro HDMI cable to the Controller Board (J3). Connect the Micro HDMI cable to PC
HDMI port.
2. Connect the Power Input cable to the Illumination Driver Board (J8).
Figure 5. EVM Cable Connections
2.2 Software Installation
1. Install the DLPC230-Q1 Control Program ( http://www.ti.com/mysecuresoftware ).
2. Install Total Phase Cheetah USB adapter drivers ( https://www.totalphase.com/products/usb-drivers-
windows ).
2.3 Powering-Up EVM
1. Connect input power cable to a power supply that meets input power specifications defined in Table 7 .
The red wire is the V+ terminal and black wire is the V– terminal.
2. Turn on the supply power. Once powered up, a Controller PCB LED indicator (D4) should illuminate
green.
3. Turn the PROJ_ON switch (SW4) ON. The ON position is towards the closest corner of the board. A
Controller PCB LED indicator (D5) should illuminate green. It is also acceptable to leave the PROJ_ON
switch in the ON position when powering on and off.