Quick Start
13
DLPU090 – November 2019
Copyright © 2019, Texas Instruments Incorporated
DLP5530Q1EVM Evaluation Module User's Guide
2.2
Software Installation
1. Download and install the
DLPC230-Q1 Control Program Lite
from ti.com.
2. Install
Total Phase Cheetah USB adapter drivers
from the Total Phase website.
2.3
Powering-Up EVM
1. Connect input power cable to a power supply that meets input power specifications defined in
.
The red wire is the V+ terminal and black wire is the V– terminal.
2. Turn on the supply power. Once powered up, a controller PCB LED indicator (D4) should illuminate
green.
3. Turn the PROJ_ON switch (SW4) ON. The ON position is away from the board, and OFF is toward the
board. A controller PCB LED indicator (D5) should illuminate green.
2.4
Connecting EVM to the DLPC230-Q1 Control Program
1. Start the DLPC230-Q1 Control Program Lite.
2. On the connection page set the DLPC230-Q1 Host to SPI and select the Cheetah from the drop down
menu (see
). Note, the Cheetah must be connected to computer with USB cable for it to show
up in the drop down box.
Figure 6. Connecting to the DLPC230-Q1 Using the DLPC230-Q1 Automotive Control Program
