CC2431
while pointing to its intended location in the blue area or background map. The X and Y
coordinates of the intended location will be set in the X and Y fields of the Reference Node
Setup tab. Press “Update” to assign the coordinates of the reference node. After a few
seconds the node will appear as a yellow circle and the X and Y values in the list will be
updated.
Figure 23: Reference Node Setup
10.2.4 Blind Node Setup
The Blind node setup tab shows all blind nodes that are present in the system and it can be
used to change the settings used for each blind node.
By double clicking on a node in the list, the present configuration values can be seen. These
values can be changed. By pressing “Update” the new settings will be transferred to the
selected node. After a few seconds the node will be updated. The status of this update
process will be shown in the column named “Status” in the device list. The parameters are
described in chapter 12.6
Figure 24: Blind Node Setup
10.3 The Status Bar
The status bar provides / displays real time status information for both the location dongle and
the Z-Location Engine in general.
Dongle
status
Number of blind node
messages
Number of
messages
Figure 25: Status Bar
SWRU076D
Page 24 of 32