Texas Instruments CC3000, Руководство пользователя

Страница: 7 / 19

SWRU331-001
Chapter 2
SWRU331A – November 2012 – Revised August 2014
CC3000 BoosterPack EVM Board
2.1 BoosterPack EVM Board Top View
Figure 2-1 shows the top view of the CC3000 BoosterPack EVM board.
Figure 2-1. BoosterPack EVM Board (Top View)
Table 2-1 describes the key parts and jumpers mounted on top of the CC3000 BoosterPack EVM board.
Table 2-1. Key Parts of CC3000 BoosterPack EVM Board Top View
Part Name Description
CC3000MOD Core module for performance evaluation. For more information, see the CC3000 module
datasheet (
SWRS126 ).
Antenna Can be used for radiated testing by reworking the capacitor to correct pads
J1 U.FL RF connector used for conductive power tests
J2 Used to swap between test mode and operation mode. When pins 2 and 3 are shorted, J2 runs in
operation mode. When pins 1 and 2 are shorted, J2 runs in test mode.
J11 Through-hole test points (for more information, see Table 2-3 )
J12 Through-hole test points (for more information, see Table 2-4 )
J13 Used to switch between external power and power from the motherboard. Can be used for power
measurements. Connect pins 1 and 2 for power from the LaunchPad flash programmer and
debugging tool. Connect pins 2 and 3 for external power.
J14 DC jack for external power supply. If power is not supplied from the motherboard, ensure that
external power is applied.
7 SWRU331A – November 2012 – Revised August 2014 CC3000 BoosterPack EVM Board
Submit Documentation Feedback
Copyright © 2012–2014, Texas Instruments Incorporated