Texas Instruments bq76PL536PGM-1, Быстрый старт

Страница: 4 / 15

Setting trimming values.
EPROM Programming Procedures
www.ti.com
4 EPROM Programming Procedures
1. Set EPROM trimming values.
(a) Set up bq76PL536EVM-3. See Section 3 or the bq76PL536EVM-3 User's Guide.
(b) Set trimming values. See Figure 3 .
2. Create programmable image.
(a) Create program image ( Figure 4 ).
(b) Enter information on optional product data ( Figure 5 ).
(c) Save image file in YYYYYY.xml format ( Figure 6 ).
(d) Save the YYYYYY.xml file to a directory.
3. Connect the Aardvark adapter to the bq76PL536PGM-1 programming board. See Section 3 .
4. Run bq76PL536A OTP EPROM Programmer Software.
5. Load the image created with bq76PL536EVM-3 ( Figure 7 and Figure 8 ).
6. Insert the integrated circuit (IC) into the socket. Check for pin 1 orientation. See Figure 10 . The 22V
and 7V LEDs must be on. If not, press the F2 function key, "Connect to Dongle". See Figure 21 .
7. Test the IC. Click the Click to Detect selection.
8. Separate pass and fail IC.
9. Insert a new IC, and repeat from step 5.
10. See Figure 9 through Figure 13 for complete sequence of EPROM programming.
Figure 3. Setting Trimming Value
4 bq76PL536PGM-1 Programming Board SLUU468A – December 2010 – Revised July 2015
Submit Documentation Feedback
Copyright © 2010–2015, Texas Instruments Incorporated