!
Features
1
Features
•
Complete evaluation system for the bq76200 High Voltage Battery Pack Front-End Charge/Discharge
High-Side NFET Driver IC
•
Populated circuit module for quick setup
1.1
Kit Contents
•
bq76200 circuit module
1.2
Ordering Information
The EVM orderable part number is bq76200EVM-606. For complete ordering information, see the product
page at
.
1.3
Documentation
See the device data sheet for bq76200 (
) on
for information on device hardware.
1.4
bq76200 Circuit Module Performance Specification Summary
This section summarizes the performance specifications of the bq76200EVM.
Table 1. Performance Specification Summary
Specification
Minimum
Typical
Maximum
Unit
Input voltage BATT+ to BATSR–
10
n/a
70
V
Output voltage PACK+ to PACK-
0
n/a
70
V
Charge and discharge current
0
2
15
A
Operating temperature
20
25
30
o
C
2
bq76200EVM Quick Start Guide
This section provides the step-by-step procedures required to use a new EVM and configure it for
operation in a laboratory environment.
2.1
Before You Begin
The following warnings and cautions are noted for the safety of anyone using or working close to the
bq76200 EVM. Observe all safety precautions.
Warning
Warning Hot surface. Contact may cause burns. Do not touch.
Caution
Do not leave EVM powered when unattended.
Danger High
The bq76200 EVM does not have an isolation boundary. If you apply high
Voltage
voltage to this board, all terminals should be considered high voltage.
spacer
Electric shock is possible when connecting the board to live wire. The
board should be handled with care by a professional.
spacer
For safety, use of isolated test equipment with overvoltage and
overcurrent protection is highly recommended.
4
bq76200 High Voltage Battery Pack Front-End Charge/Discharge High-Side
SLVU926 – July 2015
NFET Driver Evaluation Module
Copyright © 2015, Texas Instruments Incorporated