Texas Instruments BQ2573 Series, Руководство пользователя, Страница: 3 / 27

Table 1-1. I/O Description (continued)
Jack Description
J2-OTG/VAP External OTG/VAP disable pin; Logic LOW to disable OTG/VAP
J2-CELL_CONTROL External battery removal control; Logic high to pull CELL pin down
J2-ILIM_HIZ External converter disable; Logic LOW to enable HIZ mode
J3-SCL SMBUS/I2C SCL
J3-GND Ground
J3–SDA SMBUS/I2C SDA
J4-GND Ground
J4-CMPIN External CMPIN pin input
J4-CMPOUT CMPOUT pin output
J5-VBAT Connected to battery pack output
J5-PGND Ground
J6-VSYS Connected to system output
J6-PGND Ground
J7–SDA SMBUS/I2C SDA
J7-SCL SMBUS/I2C SCL
J7-GND Ground
Table 1-2 displays the controls and key parameters settings.
Table 1-2. Controls and Key Parameters Setting
Jumper Description Factory Setting
JP2
Jumper on: Forward Mode
Jumper off: Enable OTG
Installed
JP3
CELL setting
spa 1S: JP3(1-2) measure CELL pin voltage 1.2 V
spa 2S: JP3(3-4) measure CELL pin voltage 2.7 V
spa 3S: JP3(5-6) measure CELL pin voltage 3.9 V
spa 4S: JP3(7-8) measure CELL pin voltage 4.2 V
spa 5S: JP3(9-10) measure CELL pin voltage 6.0 V
JP3(3-4) installed
JP4
Jumper on: Bat removal
Jumper off: Cell setting by JP3
Not installed
JP6
HIZ Enable
spa Jumper on: Enable HiZ mode.
spa Jumper off: ILIM is set by external resistor divider
Not installed
JP8
Jumper on: Onboard LDO to drive the EVM 3V3
Jumper off: disconnect onboard LDO to drive the EVM 3V3
Installed
www.ti.com Introduction
SLUUCB9A – JUNE 2020 – REVISED JANUARY 2021
Submit Document Feedback
BQ2573X Evaluation Module 3
Copyright © 2021 Texas Instruments Incorporated