Texas Instruments BQ25306EVM, Руководство пользователя

Страница: 2 / 19

1 Introduction
The BQ25306EVM is an evaluation kit for the BQ25306 integrated battery charge management IC.
1.1 Features
For detailed features and operation, refer to Table 1-1 for a list of devices and their data sheets.
Table 1-1. Device Data Sheets
Device Data Sheet EVM Label Variant
BQ25306 SLUSDC7 BQ25306EVM BMS005-004
The BMS005 evaluation module (EVM) is a complete charger module for evaluating an integrated, standalone,
synchronous buck battery charger using any of the devices listed above.
1.2 I/O Descriptions
Table 1-2 lists the input and output connections available on this EVM and their respective descriptions.
Table 1-2. EVM I/O Connections
Jack Description
J1(1) –GND Ground
J1(2) –EXT_TS Connect to thermistor of external battery
J1(3) – BATTERY Positive rail of the charger battery input, connected to the positive
terminal of the external battery
J2(1) –GND Ground
J2(2) –VIN Positive rail of the charger input voltage
Table 1-3 lists the jumper and shunt installations available on this EVM and their respective descriptions.
Table 1-3. EVM Jumper and Shunt Installation
Jack Description BQ25306 Setting
SH-JP1 EN pull-up rail selection.
1-2 pulls EN up to external VDD (EN_CTRL either REGN or external voltage source depending on
JP3 configuration.)
2-3 pulls EN down to GND. JP1 2-3 Installed
SH-JP2 POL pull-up rail selection.
1-2 POL pull down to GND. Shunt Not Installed
SH-JP3 EN external VDD rail selection (EN_CTRL)
1-2 pulls EN_CTRL to external voltage supply connected to JP3-1
2-3 pulls EN_CTRL to REGN Shunt Not Installed
SH-JP4 Set charge regulation voltage of BQ25306 to 4.2V Installed
SH-JP5 Set charge regulation voltage of BQ25306 to 8.4V Shunt Not Installed
SH-JP6 VSET Short to GND.
For charge regulation voltage corresponding to this setting, refer to datasheet of the respective
battery charger IC shown in
Table 1-1 .
Jumper Not Installed
SH-JP7 VSET Resistor pull down to GND of 10.2kΩ
For charge regulation voltage corresponding to this setting, refer to datasheet of the respective
battery charger IC shown in
Table 1-1 .
Jumper Not Installed
SH-JP8 VSET Resistor pull down to GND of 51.1kΩ
For charge regulation voltage corresponding to this setting, refer to datasheet of the respective
battery charger IC shown in
Table 1-1 .
Jumper Not Installed
SH-JP9 ICHG Resistor pull down to GND with 40.2kΩ to set charge current to 1A.
Populate both SH-JP9 and SH-JP10 to program 3A charge current. Installed
SH-JP10 ICHG Resistor pull down to GND with 20kΩ to set charge current to 2A.
Populate both SH-JP9 and SH-JP10 to program 3A charge current. Shunt Not Installed
For recommended operating conditions, refer to data sheet of the respective battery charger IC shown in Table
1-1 .
Introduction www.ti.com
2 BQ25306 (BMS005) Evaluation Module SLUUC50A – MARCH 2020 – REVISED DECEMBER 2020
Submit Document Feedback
Copyright © 2020 Texas Instruments Incorporated