Texas Instruments bq24295EVM-549, Руководство пользователя

Страница: 3 / 21

www.ti.com
Introduction
1.4 I/O Description
Table 1 contains the EVM connections.
Table 1. EVM Connections
Jack Description
J1-PMID PMID pin connection or power bank output
J1-GND Ground
J2-V
BUS
Input: positive terminal
J2-GND Input: negative terminal (ground terminal)
J3-SYS Connected to system
J3-GND Ground
J4 USB-to-GPIO connector (USB Interface
Adapter Connector - HPA172)
J5-BAT+ Connected to battery pack
J5-GND Ground
J6 Mini_USB connector
J7-INT INT pin connection
J7-OTG OTG pin connection
J7-CE CE pin connection
J7-GND Ground
Table 2 lists the jumper connections for this EVM.
Table 2. Jumper Connections
Jack Description Factory Setting
JP1 VSYS pull-up for STAT, PG, INT, CE, SCL, SDA Shunt installed
JP2 200- Ω short between D+ and D– Shunt not installed
JP3 TS1 to GND fault Shunt not installed
Table 3 lists the switch settings for the EVM.
Table 3. Switch Settings
Switch Description Procedure Setting
S2-1 OTG switched to GND: ON OFF
S2-2 CE switched to GND: ON OFF
S2-3 TS 10 k
Ω
switched to GND: ON ON
S2-4 REGN switched to TS divider: ON ON
PSEL/PG (left) or D+/D– (Right)
S3 Right
Connection
Table 4 gives the recommended operating conditions for this EVM.
Table 4. Recommended Operating Conditions
Symbol Description MIN TYP MAX Unit
Supply voltage, V
IN
Input voltage from AC adapter input 3.9 5 6 V
Battery voltage, V
BAT
Voltage applied at V
BAT
terminal 3.7 4.25 V
Supply current, I
AC
Maximum input current from AC adapter input 3 A
Output current, I
OUT
Output current 4 A
Operating junction temperature range, T
J
0 125 °C
3 SLUUAO5B – August 2013 – Revised April 2014 bq24295EVM-549 (PWR549) User’s Guide
Submit Documentation Feedback
Copyright © 2013–2014, Texas Instruments Incorporated