5.4 Initial Required Setup on the Config Tab
After the EVM GUI is started, press the
Initialize USB
,
Power Up
,
Program FPGA
, and
Initialize ADS98xx
buttons to setup the initial configurations. As shown in
, press these buttons in order from top to
bottom. Wait after each button press for the status to indicate that the step is complete. For the
Power Up
and
Program FPGA
buttons, some status LEDs on the hardware illuminate. The power-up step takes the longest
time (approximately 30 seconds). After all four buttons are pressed, the power on the ADS9817EVM is on and
the ADS9817 device registers are configured.
Press the bu
ons circled below.
Wait a
er each bu on press for
the status to indicate that the
step is complete.
Figure 5-7. Initial Required Setup on the Config Tab
EVM Operation
SBAU416 – NOVEMBER 2022
ADS9817EVM-PDK Evaluation Module
13
Copyright © 2022 Texas Instruments Incorporated