Introduction
5
SLAU485A – January 2013 – Revised April 2016
Copyright © 2013–2016, Texas Instruments Incorporated
ADS4449 EVM User Guide
Table 2. ADS4449 EVM Connectors (continued)
Reference Designator
Description
J13
CH D input (positive)
J14
CH D input (negative) DNI
The on-board jumper options allow configuration of on-board power supplies and ADC options. Many of
the jumper selections that involve DC inputs or static control signals are by way of push-on square post
jumpers. The jumper options are listed in
. The table indicates the default settings of the jumpers
as the EVM is normally shipped. Some of the jumpers are open circuit by default.
Table 3. ADS4449 EVM Jumper Options
Reference
Designator
Default
Setting
Function
Optional
Setting
Function
JP1
DNI
Connects low-noise LDO (U2) input to main
power input
N/A
JP2
1-2
Connects DC/DC converter (U3) output to low-
noise LDO (U2) input
2-3
Connects DC/DC converter (U3) output
directly to the ADC
JP3
1-2
Connects low-noise LDO (U2) output to ADC
2-3
Connects DC/DC converter (U3) output
directly to the ADC
JP4
DNI
Connects low-noise LDO (U4) input to main
power input
N/A
JP5
1-2
Connects DC/DC converter (U3) output to low-
noise LDO (U4) input
2-3
Connects DC/DC converter (U3) output
directly to the ADC
JP6
1-2
Connects low-noise LDO (U4) output to ADC
2-3
Connects DC/DC converter (U3) output
directly to the ADC
JP7
2-3
Connects ADC RESET pin G6 to SW1 RESET
switch
1-2
Connects ADC RESET pin G6 to DRVDD
JP8
1-2
N/A
Open
N/A
JP9
2-3
N/A
1-2
N/A
JP10
1-2
N/A
Open
N/A
JP11
2-3
Enables ADC
1-2
Power down the ADC or allows the ADC
to standby (configured by CONFIG 0x45,
bit D0)
JP12
2-3
N/A
1-2
N/A
There are two pushbuttons on the EVM. While JP7 is set in the 2-3 position, the pushbutton switch, SW1,
provides a hardware reset to the ADS4449. Upon powering up, the ADC can either accept a hardware
reset by pressing SW1 or by toggling the software reset switch on the EVM GUI. Pushbutton SW2 is not
used.
lists the descriptions of each pushbutton switch.
Table 4. ADS4449 EVM Pushbutton Switches
Reference
Designator
Purpose
SW1
While JP7 is set in the 2-3 position, pressing SW1 resets the ADC. The ADC can be reset either by pressing
SW1 or with a software reset in the GUI.
SW2
N/A
LED D1 is lit indicating the presence of the 6-V supply voltage to the EVM, while LED D2 is lit indicating
the presence of the USB to serial converter power. LEDs D3 and D4 are not used.
lists the
description of each LED indicator.
Table 5. ADS4449 EVM LED Indicators
Reference
Designator
Description
D1
When lit, D1 shows the presence of the 6-V (main) power supply
