ADS1282EVM-PDK Kit Operation
9.2
Setting Up the ADS1282EVM-PDK
The ADS1282EVM-PDK contains both the ADS1282EVM and the MMB0 motherboard; however, the
devices are shipped unconnected. Follow these steps to set up the ADS1282EVM-PDK.
Step 1.
Unpack the ADS1282EVM-PDK kit.
Step 2.
Set the jumpers and switches on the MMB0 as shown in
.
•
Set the Boot Mode switch to USB.
•
Set jumper J4 low to indicate that the EVM board is an ADS1282EVM.
Figure 5. MMB0 Initial Setup
9
SBAU144C
–
March 2009
–
Revised May 2011
ADS1282EVM and ADS1282EVM-PDK User
'
s Guide
Copyright
©
2009
–
2011, Texas Instruments Incorporated