Texas Instruments ADS1254, Руководство пользователя

Страница: 15 / 40

Quick Start
2-3 Getting Started
2.3 Quick Start
Once the ADS1254EVM has been unpacked from its shipping container, and
you have verified that the board is configured as shown in Table 2−1, it can be
powered on and tested.
First, connect the board to the host PC using the supplied 9-pin serial cable.
Then power the board on by plugging a wall power adapter into a suitable ac
power source and plugging the barrel plug into the barrel jack on the
ADS1254EVM, or by connecting your laboratory power supply to the external
power inputs and setting JMP2 and JMP3 to the 2−3 position. (You do not have
to connect the serial cable first; it is also acceptable to apply power to the board
first.) When the board is properly powered on, the two power good indicator
lamps near the power connectors glow brightly. (The 5-V LED may glow
brighter than the 3.3-V LED; this is normal.)
Place the CD-ROM into your PCs CD-ROM drive. Locate the setup program
on the disk, and run it. The setup program installs the ADS1254EVM software
on your PC. If you are running a Windows platform that is NT-based, such as
Windows NT or Windows 2000, you need administrator privileges to install the
software. Follow the instructions that the installer gives you.
Once the program has been successfully installed, it can be executed. When
the program is run, it displays a title screen, and then you see something like
the display in Figure 2−1.
Figure 2−1. Start-Up Display