ADS1246EVM-PDK Kit Operation
7.3
Default Jumper Settings and Switch Positions
shows the jumpers found on the EVM and the respective factory default conditions for each.
Figure 3. ADS1246EVM Default Jumper Locations
lists the switches found on the EVM and the respective factory default conditions for each.
Table 6. List of Switches
Switch
Default Position
Switch Description
S1
Left
Onboard reference
8
ADS1246EVM-PDK Kit Operation
This section provides information on using the ADS1246EVM-PDK, including setup, program installation,
and program usage.
To prepare to evaluate the ADS1246 with the ADS1246EVM-PDK, complete the following steps:
Step 1.
Install the ADCPro software (if not already installed) on a PC.
Step 2.
Install the ADS1246EVM-PDK EVM plug-in software.
Step 3.
Complete the USB driver installation process.
Step 4.
Set up the ADS1246EVM-PDK.
Step 5.
Connect the ADS1246EVM-PDK to the computer with a USB cable.
Step 6.
Run the ADCPro software.
Each task is described in the subsequent sections of this document.
8
ADS1146EVM, ADS1246EVM, ADS1146EVM-PDK, ADS1246EVM-PDK
SBAU149B
–
June 2009
–
Revised May 2011
Copyright
©
2009
–
2011, Texas Instruments Incorporated
