www.texas.dk
Side 11
6. Fitting the hose
Fit the hose onto the intake on the pump. Fasten it with the clips supplied.
7. Prime
METHOD
Supply of water. When the pump is started for the first time it is necessary to pour water onto the pump
manually:
5. Remove the cover at the top op the pump
6. Pour water into the pump (the pump housing must be filled)
7. Fit the cover
8. Start the pump
8. Use
-
Hose
o
Make sure that the hose is not overloaded. It should be supported so that it will not be
damaged
o
Only use hoses with correct length. Too long hoses will make transport time longer and wear
the pump down quicker
-
Filter
o
Always use a filter at the end of the hose where the water runs into the hose. This ensures
that no dirt gets sucked into the pump. Dirt may damage the pump
-
Impeller
o
Because of great wear it may be necessary to often change the impeller.
OUT
IN
