Texas Equipment ADC14X250EVM, Руководство пользователя

Страница: 12 / 19

Software Description
www.ti.com
4.2 Low Level View
The Low Level View tab, shown in Figure 6 , allows configuration of the devices at the bit and field level. At
any time, the controls described in Table 5 may be used to configure or read from the device.
Table 5. Low Level View Controls
Control Description
Register Map Displays the devices on the EVM, registers for those devices, and the states of the registers.
● Selecting a register field allows bit manipulation in the Register Data section.
● The Value column shows the value of the register at the time the GUI was last updated due to a read
or write event.
Write Register Button Write to the register highlighted in the Register Map with the value in the Write Data field. This button must
be clicked after changing bits in the register data section.
Write All Button Update all registers shown in the Register Map with the values shown in the Register Map summary.
Read Register Button Read from the register highlighted in the Register Map and display the results in the Value column.
Read All Button Read from all registers in the Register Map and display current state of hardware. Also updates the
controls in the other tabs.
Load Config Button Load a Configuration File from disk and write the registers in the file.
Save Config Button Save a Configuration File to disk that contains the current register configuration.
Register Data Cluster Manipulate individual accessible bits of the register highlighted in the Register Map.
Generic Read/Write Perform a generic read or write command to the device shown in the ‘Block’ drop-down box using the
Register Buttons Address and Write Data information
Figure 6. Low Level View Tab
12 ADC14X250EVM Evaluation Module SLAU625 – November 2015
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated