Texas Equipment 90070042, Руководство пользователя

Страница: 12 / 16

12
7. Use
See Fig. 3
Before use, make sure that the battery is fitted properly
with the battery lock in place.
To start the machine first press the main switch (1), so
the On/Off indicator (2) lights green. Then hold the
safety switch (3) on front handle and activate the trigger
switch (4).
For safety reasons, the hedge trimmer only works when
both switches are activated (3+4)
Stop the hedge trimmer by releasing the trigger switch
(4) or the front handle switch (3).
The free gab between the blade teeth is 22 mm, but to
ensure enough power to cut each branch nicely and
avoid the blade getting blocked, it is recommended to
avoid branches larger than 18 mm depending on hedge
type. Use a handsaw or pruning cutter to trim the larger
branches.
Automatic switch off function
The machine is equipped with a switch off function that
deactivated the machine if not used within approx. 60
seconds. The green power indicator light will switch off
too. Press the main switch (1) to restart.
8. Clothing
When using the machine, wear tight-fitting work clothes,
strong working gloves, hearing protectors, safety
goggles and boots with non-skid soles
9. Rotatable rear handle
See Fig. 4
The rotatable handle has 5 positions. Spend some time
finding the position that is right for you.
The rotatable handle makes the work more
ergonomically correct.
To change position pull the lock and turn the handle.
The trigger switch must not be activated when turning
the handle, as it will prevent it to turn.
10. Tips and advices
See Fig. 5
Always use both hands to hold the machine.
Hold the machine at the side of your body (A)
Work with a swinging action from the bottom and
upwards when trimming sides (B). It is recommended to
turn the rotatable rear handle 90 degrees when doing
this for optimal ergonomy.
When trimming a hedge, the motor should always face
away from the hedge. Hold the machine as close to
your body as possible to get the best balance.
Make sure that the tip does not touch the ground.
Apart from hedges the hedge trimmer may also be used
for cutting bushes.
The best cutting effect is achieved
when holding the blade at an angle to the hedge of
approx. 15
°
.
The opposite rotating knives cut on both sides, and it is
therefore possible to trim the hedge in both directions.
The illustration shows how the hedge trimmer is used to
get the optimal result.
11. Maintenance
Before any service and maintenance is done,
the power must be disconnected, it means the
battery removed from the tool.
•
Remove the battery before you clean and store the
machine.
•
For obtaining the best cutting results the knives
must be cleaned and oiled regularly. Remove dirt
with a soft brush and oil lightly.
•
Use biodegradable oil.
•
Clean the housing and other parts with a mild
cleanser and a moist cloth. Never use aggressive
cleansers or solvents.
•
Prevent water from getting into the machine.
12. Storage
Store the hedge trimmer dry and unavailable for
children. Keep the blade lubricated. Use the transport
protection when the machine is stored.
13. Specifications
Model HTZ 5800
Battery type Lithium Ion
Battery nominal voltage 58V
Battery rated voltage 50.4V
Motor power 550W
Blade speed Max 3000 cuts/min
Blade length 65 cm
Cutting diameter Max 22 mm
Net weight (tool only) 3.0 kg