TPCE261 User Manual Issue 1.0.2
Page 7 of 20
2 Technical Specification
Mechanical and Electrical Interfaces
PCI Express
PCI Express x1, Revision 2.0
max. 2.5GT/s link speed
Standard Height
Half-Length
PMC Slot
PCI Mezzanine Card (PMC) Interface conforming to
IEEE P1386/P1386.1
Single-Width
PCI Rev. 2.3 compliant
33/66 MHz / 32-Bit PCI
3.3V and 5V PCI Signaling Voltage
PMC Interface
Number of PMC Slots
1
PMC I/O Access
PMC Front Panel I/O
PMC P14 Rear-I/O through 68-pin ERNI SMC, right angle male,
1.27mm pitch connector
Maximum Current for P14 Rear I/O Lines is 0.5A!
On-Board Devices
PCIe-to-PCI Bridge
XIO2001 (Texas Instruments)
Physical Data
Power Requirements
-
@ +3.3V DC
100mA maximum
@ +12V DC
Additional power is required by the PMC Module!
Power Stable for PMC Slot
The power supply for the PMC slot is stable approximately 5ms
after the system power supply is stable.
Maximum Power for PMC Slot
The maximum power available for a PMC module is variant
dependent. Please see chapter “Power Limits for PMC Modules”
for detailed information.
Temperature Range
Operating
Storage
-40°C to +85°C
-40°C to +85°C
MTBF
TPCE261-1xR: 599000h
TPCE261-2xR: 533000h
MTBF values shown are based on calculation according to MIL-HDBK-217F and
MIL-HDBK-217F Notice 2; Environment: G
B
20°C.
The MTBF calculation is based on component FIT rates provided by the
component suppliers. If FIT rates are not available, MIL-HDBK-217F and
MIL-HDBK-217F Notice 2 formulas are used for FIT rate calculation.
Humidity
5 – 95 % non-condensing
Weight
TPCE261-1xR: 97 g
TPCE261-2xR: 99 g
Table 2-1 : Technical Specification
