GENERAL SAFETY
When using electric equipment basic safety precautions should always be followed to reduce the
risk of fire, electric shock and personal injury. Read all these instructions before attempting to use
the equipment.
Consider the environment.
Do not use in damp or wet conditions. Do not use without adequate light. Do not use near
flammable or hazardous materials. Care must be taken when using headphones outdoors to avoid
possible water damage.
Keep children away
.
This appliance is not intended for use by young children or infirm persons without supervision.
Young children must be supervised to ensure that they do not play with the equipment.
Damaged or dropped.
Always inspect your electrical equipment before use. Do not use this equipment if it has been
damaged, dropped, left outdoors or dropped in water. Return it to an authorised service dealer for
examination and repair. Do not attempt to service this equipment yourself. Refer servicing to
qualified service personnel.
Store in a safe place
When not in use store your cordless headphone and all its accessories and instruction manual in a
safe and dry place.
Liability.
No liability can be accepted for any damage or personal injury caused by non-compliance with
these instructions or any other improper use or mishandling
.
This equipment is intended for
household use only.
CARE AND CLEANING
Before cleaning.
When not in use or before cleaning, always disconnect from the mains supply.
Cleaning guide.
Regularly clean the outside of the equipment with a soft damp cloth and dry it with a dry towel. Do
not immerse in water. Do not use harsh solvents to clean the plastic components.
TROUBLE SHOOTING
NO SOUND:
- Ensure that the AC power pack is correctly inserted into the AC wall outlet and that it is on.
- Ensure that the headphones ON/OFF switch is set to the ON position
- Headphone batteries may be low, see recharging instructions
- Adjust the volume control dial on the headphones to turn up the volume
- Check the audio source that is supplying the signal for transmission (Is it “playing”)
DISTORTED:
- Ensure that the transmitters green stereo indicator light is on
- Change the position of the FREQ ADJUST control located on the rear of the transmitter. Retune
the headphones TUNE CONTROL dial to re-establish a clear connection
- The headphone batteries may be too low, turn off the headphones; recharge or replace the
batteries and then switch the headphone back to the on position.
- The headphones may be too far away from the transmitter.
- The input signal from the audio source may be too low, increase the output volume of the source
device if possible and retry.