7
• Transmitter Subconnect TX
Setup/Wall Mounting
Setup location
NOTICE
If the device is subjected
to warm temperatures after
being cold (e.g. after trans-
port), condensation may occur
inside of it.
–
In this case, wait at least 2
hours before you connect
and activate it.
CAUTION
–
This Subconnect TX is dis-
connected from the mains
by pulling the mains adapter.
Therefore, make sure that
the mains adapter is always
easily accessible.
• Select a stable, level base.
In case of wall mounting, follow the
instructions in the next chapter.
• Make sure that the environment is
clean and free from dust.
• Select a location away from heat
sources and direct sunlight.
• Lay the connector cables so that
they do not pose a tripping hazard.
• Do not place any heavy objects on
the cables or the device.
Wall mounting
For wall installation, 2 keyhole open-
ings are located on the bottom of the
Subconnect TX that can be used to
hang it on 2 screws.
CAUTION
–
Make sure that there are no
cables or pipes in the wall
where you intend to mount
the device. Before you drill
holes for the dowels, use a
metal detector to check the
applicable areas. Otherwise,
there is a risk of electric
shock/short circuit!
