11
• S 6000 SW THX® Select
Use And Settings
Activating and deactivating
–
Use the switch
(7)
to switch the S 6000 SW THX
®
Select on and off.
The CLIP LED
(10)
will briefly illuminate in red
during activation.
When switched on, the power indicator
(14)
will
be illuminated in red.
Automatic activation/deactivation
–
You can switch the mode with the POWER switch
(9)
:
ON
The subwoofer is permanently switched on.
AUTO
The subwoofer switches itself on as soon
as an audio signal is present. If there’s no
audio signal for approx. 20 minutes, the
subwoofer switches to standby.
–
If the auto-function doesn’t switch correctly, you
can use the AUTO LEVEL control
(11)
to increase
the sensitivity (turn to the right) or decrease it
(turn to the left). You will need a small screwdriver
to do this.
Establishing a wireless connection
If you have installed the Subconnect receiver
module for a wireless connection (see „Wireless
connection“ on page 11), you can establish the
connection to your amplifier as follows:
1. If applicable, slide the INPUT switch
(5)
to the
“WIRELESS” position.
2. Switch your subwoofer and your wireless-compat-
ible amplifier or also the Subconnect transmitter
on.
The STATUS LED
(2)
will blink slowly and the
devices will now automatically connect. An
existing connection is indicated by the continu-
ously illuminated STATUS LED
(2)
.
Proceed as follows to connect for the first time or
if the devices do not connect automatically or the
connection is interrupted:
1. Hold down the PAIRING button
(13)
until the
STATUS LED
(2)
blinks quickly.
2. Then perform the corresponding steps for your
amplifier to establish the connection (for this,
refer to the user manual for your amplifier).
7
14
9
10
11
2
13
5
