10
• AmpStation
Make sure the polarity is correct!
– Connect the like coloured terminals.
Otherwise, the sound quality will
suffer.
– The strands of the speaker single
wire are marked with different col-
ours or shapes.
1. Turn the connector terminals
(5)
counterclockwise until loose.
5
SPEAKER OUT 4 - 8 OHMS
2. Split the speaker cables down to
approx. 30 mm on both ends.
3. Remove approx. 10 mm of the insu-
lation on each end.
4. Twist the single wire so that no
strands are protruding.
5. Run the stripped cable end into the
now visible hole.
6. Close the terminal by turning it
counter-clockwise. The cable has
now been clamped in place.
Inputs
Connect the jacks
LINE IN (6)
of the
AmpStation with the output jacks of
your preamplifier, such as a Decoder-
Station. You will need up to 4 stereo
RCA cables for this.
6
Link
If using a compatible preamplifier from
Teufel (e.g. a DecoderStation), you
can connect the AmpStation with the
preamplifier via the connection
LINK
(8)
. Thus, the devices are switched on
and off together.
For this you will need the supplied
Teufel Link connector cable.
8
