Page 3
1. Remove the cover
②
from the base plate
①
.
2. Hold the base plate
①
against the wall at the desired loca-
tion and mark the four drill holes horizontally.
3. Drill holes with a diameter of 8 mm in the wall at the
marked positions.
4. Insert four masonry plugs
⑥
in the drill holes.
5. Run the speaker cable through the holes in the base plate
①
from below.
②
⑤
①
⑥
Speaker cable
6. Screw the base plate
①
on the wall using four half round
head screws
⑤
.
7. The
cover
②
is marked with “TOP” and “DOWN” inside.
Run the upper end of the speaker cable through the upper
hole in the cover
②
.
8. Put the cover
②
on the base plate
①
. In the process, the
speaker cable must be run through the notches on the
front and bottom side.
9. Place the bracket
③
on the base plate
①
and insert the
carriage bolt
④
from above. Ensure that the square of the
carriage bolt exactly fi ts into the square hole of the bracket
③
.
④
①
⑨
⑦
③
10. Tighten the carriage bolt
④
with the washer
⑨
and the nut
⑦
.
11. If necessary, loosen the screws
⑪
and change the inclina-
tion of the bracket
③
.
To align the wall mount horizontally, loosen the nut
⑦
,
align the bracket
③
with the listening zone and tighten the
nut
⑦
again.
③
⑪
⑦
12. Screw tighten the speaker on the bracket
③
using the
screw
⑧
.
⑧
③
Assembly