Page 3
1. Remove the cover
⑤
from the base plate
④
.
2. Hold the base plate
④
against the wall at the desired loca-
tion and mark the four drill holes horizontally.
Important
: The base plate must be rotated by 90° for
mounting a center speaker in landscape format.
3. Drill holes with a diameter of 6 mm in the wall at the
marked positions.
4. Insert four masonry plugs
⑨
in the drill holes.
5. Run the speaker cable through the holes in the base plate
④
from below.
⑤ ⑧
④
⑨
Speaker cable
6. Screw the base plate
④
on the wall using four half round
head wood screws
⑧
.
7. The
cover
⑤
is marked with “TOP” and “DOWN” inside.
Run the upper end of the speaker cable through the upper
hole in the cover
⑤
.
8. Put the cover
⑤
on the base plate
④
. Do not pinch the
speaker cable in the process!
9. Place the bracket
⑥
on the base plate
⑤
and insert the
screw
⑦
with a washer
⑬
from above.
⑦
⑬
④
⑬
⑩
⑥
10. Tighten the screw
⑦
with a washer
⑬
and a nut
⑩
.
11. From the three retaining plates
① ② ③
, choose the one
which fi ts the hanger of your speaker:
①
for a hole spacing of 30, 31 or 32 cm
②
for a hole spacing of 27 cm
③
for a hole spacing of 20.5 cm
Hole
spaci
n
g
①
②
③
12. Screw tighten the appropriate retaining plate to the
bracket
⑥
using four screws
⑪
and four nuts
⑭
.
⑪ ⑫
①
②
③
⑩
⑭ ⑥
13. Loosely screw the two retaining bolts
⑫
on the top and
bottom of the retaining plate
①
,
②
or
③
using one nut
⑭
each (only two to three turns).
Assembly
