4 Zone DMX and RF wall panel
for RGB and RGBW LED strip
www.teucerled.co.uk
V002-11-2019
ZONE
ZONE
ZONE
ZONE
BRT/SPEED
WHITE
POWER
MODE
Press the zone
you wish to allocate
Troubleshoot
Problem
Cause
Corrective
No light
• No power.
• Wrong connection or unsecure con-
nection.
• Check the power.
• Check the connection.
Wrong Colour
• Wrong connection of RGB/W wires.
• Retrace and reconnect RG-
B/W wires.
Uneven intensity
between front and
rear of the strip,
with voltage drop
• Output cable is too long.
• Cable diameter is too small.
• Overload beyond driver capability.
• Overload beyond receiver capability.
• Reduce cable or loop supply.
• Change to a thicker cable.
• Replace with a suitable high-
er power driver.
• Add a power repeater.
No response
from the remote
• The wall panel has no power.
• Beyond controllable distance.
• The controller isn’t synchronised with
the remote.
• Check the incoming supply
to the wall panel.
• Reduce remote to receiver
distance.
• Re-sync the remote.
2)
Choose the zone you wish to allocate on the panel within 5 seconds after pressing the match button.
The LED indicator on the receiver will flash rapidly 5 times and then stop flashing. The controller is now
synchronised with the receiver.
3)
Repeat the process to allocate zones for all
receivers.
Note! RF technology allows for greater flexibility when it comes to controlling simple or complex lighting installations
without the need of additional cabling. There are some limitations where installations have the receivers enclosed in
electrical boxes or hidden away in a ceiling , reducing the RF signal strength and therefore the communication range.
In order to overcome these RF Signal restrictions we suggest the following when synchronising our RF controllers and
receivers:
•
Keep the distance within 10 meters from the controller to the receiver. The remote can operate up to 30 meters if
signal is uninterrupted by obstacles.
•
When expanding your lighting, always try and use a signal repeater (PR-RGB(N)), where possible.
4)
To restore the receiver to the factory default settings
and delete the allocated controller, press and hold the
match button on the receiver longer than 5 seconds
until the LED indicator flashes quickly 5 times.
MODE
Starting Address/
1st Channel
2nd Channel
3rd Channel
4th Channel
RGB/RGBW Zone 1
001
002
003
004
RGB/RGBW Zone 2
005
006
007
008
RGB/RGBW Zone 3
009
010
011
012
RGB/RGBW Zone 4
013
014
015
016
R
G
B
W Decoder Nr.
001 002 003 004 Decoder 1
005 006 007 008 Decoder 2
009 010 011
012 Decoder 3
013 014 015
016 Decoder 4
Addresses for the RGB / RGBW
mode when using multiple
decoders
Synchronising the wall panel to the DMX decoder
Address Setting in RGB/RGBW modes when using a single decoder:
