TetraLite TetraMouse TMXS, Настройка

Страница: 17 / 21

Page 14
OPERATING OPTIONS AND TIPS
KNOB OPTIONS
TIPS AND TECHNIQUES
The TetraMouse comes with 5/8-inch diameter round knobs as standard
equipment, but other knobs are available such as the Cup Knobs that may
be used to operate the TetraMouse with the tongue or finger, and Bulb Knobs
that bend easily and are intended for use by people with motor control issues
in order to avoid personal injury or damage to the TetraMouse. All knob
options are interchangeable. Knobs are easily removed by pulling them off,
and installed by
pushing them on.
The joystick shafts are threaded, but the tough flexible material of the knobs
allows them to be installed and taken off without damaging the threads or
the knobs. The threaded shafts also allow installation of older screw-on
TetraMouse knob styles. See the tetramouse.com website for all current
knob styles.
MOUSE POINTER SPEED - It is recommended that the Windows mouse
default pointer speed settings be used when first setting up the
TetraMouse. From the Control Panel, open Mouse Properties (Mouse)
and click on the “Pointer Options” tab. The Motion slider should be set to
the center position half way between “Fast” and “Slow”. This setting will
affect all the TetraMouse speed settings proportionally.
It is recommended that any third party mouse drivers be uninstalled if the
TetraMouse seems to run excessively fast or slow.
If you use an operating system other than Windows, start with the default
settings and make adjustments to pointer speed if desired.