Tetra LightWave Complete Set 1140, Инструкция по эксплуатации

Страница: 10 / 136

10 LightWave Complete Set
UK
ATTACH LED LIGHTING WITH CLIPS
The clips can be screwed on or attached to the aquarium wall with suction
cups.
Procedure:
Fig. C
• Maintain the specified distance between the clips.
• Attach clip using screws: use flat head screws only, no countersunk
screws.
– Screw the clip onto a firm base so that the LED light is held in place
securely.
NOTICE: The screw head must be totally flush with the nut to avoid
damaging the LED lighting.
• Attach clip using suction cups: to ensure that the suction cups hold
securely, moisten and use on smooth, grease-free and clean surfaces.
INITIAL USE
CAUTION
Strong LED radiation can dazzle and injure your eyes.
• Never look at the light source directly for an extended period of time.
The power supply can operate the LED lighting supplied and no more than one
additional LED lighting of the LightWave range. The additional light is available
as a LightWave Single Light . A LightWave Splitter is required to operate two
LED lights.
• Only use the
LightWave Splitter with LightWave LED lights of the same
length.
Procedure:
Fig. D
1. Connect all components and connect the power supply to the mains.
– Do not attach electric accessories, such as the power supply, to the
aquarium in order to avoid contact with water.
2. To switch the device on and off, use the switch on the power supply.