TESY HL-243VB W, Инструкции по использованию и хранению, Страница: 6 / 108

6
Usage and Storage Instructions
EN
3.
Turn two stainless steel screws into the anchors and
leave 2.5 mm of the screw out (pic 3)
2.5
3
4.
Put the appliance to the wall, pull down until it
secured. (pic 4)
4
5.
After securing it firmly to the bottom two screws,
screw the last three screws as picture
5
OPERATION
Push the ON/OFF (0/I) button located at the back of
the appliance to connect power supply. There is a “D”
sound and screen will display in full for 3 seconds, then
appliance enters into standby mode. Push ON/OFF (0/I)
button again to disconnect power supply.
Prog
Mode
On/standby switch
Program
setting
Power setting
Mode switch:
Р1, Р2, Р3,
Р4, Р5, UP
Window
open detection
Plus button
for timer/
temperature
Minus button
for timer/
temperature
LED display
Timer
Icon Meaning
working at Full power 2000W
Working at 1000W
Anti-frost function
Window open detection function
Timer function to switch off
d1, d2, d3, d4,
d5, d6, d7
Mon. Tue. Wed. Thur. Fri. Sat. Sun.
P1,P2,P3,P4,P5 Factory pre-set program
UP
Self-program setting
Press , once to switch on the appliance. Press again
to switch it off.
1. Set Current Day and Time:
When appliance is ON, long press for 3 seconds to
activate current day setting.
1).
Screen will display d1 and it flashes, then press or
to set Day of the week among
d1, d2, d3, d4, d5,
d6, d7 in cycle. Press once to confirm the current
day setting.
2). Then appliance enter into time setting. Hour icon
flashes, press or to set current hour among
00-23 in cycle. Press once to confirm hour.
3). Then follow the same way to set minutes. Finally
press once to confirm setting.
After setting finish, press once in standby mode
to check if the current day and time setting is correct.
Screen will automatically show Day, Hour, Minutes
in turns within1 second each, then switch back to
temperature display.
For exampe, you have set today is Wed. 12:45 a.m.,
screen will show d3, 12: 45 accordingly.
Note:
At the first usage, icon will keep flashing until
current day and time are set. Please finish the setting
before any other usage.