TESTO 922, Инструкция по эксплуатации

Страница: 10 / 21

5. Operation 30
Each radio probe has a probe ID (RF ID). This consists of
the last 3 digits of the serial no. and the position of the
slide switch in the radio probe (
H
or
L
).
Configuration mode is opened and RF ID and Auto are
lit.
The radio probe is switched on.
1
Select the desired option with and confirm with
:
·
YES
: Switches automatic probe detection on
(recommended).
·
no
: Switches automatic probe detection off.
no was selected:
2
Use / to set the probe ID manually and
confirm with .
YES
was selected:
- Automatic probe detection is started. Auto flashes
while the instrument looks for a radio probe that is
switched on.
- Once a radio probe is found, the probe ID is
displayed. If no probe is found,
NONE
lights up.
Possible reasons why probes are not found:
· The radio probe is not switched on or the
battery of the radio probe is spent.
· The radio probe is outside the range of the
measuring instrument.
· Sources of interference are influencing the radio
transmission (e.g. reinforced concrete, metal
objects, walls or other barriers between
transmitter and receiver, other transmitters of the
same frequency, strong electromagnetic fields).
i
If necessary, rectify the possible causes for the
disruption to the radio transmission and start
automatic probe detection again with
.