TESTO 184 T1, Инструкция по эксплуатации

Страница: 15 / 18

5 Maintaining the product
15
• To transfer data, the data logger must be placed on the NFC
transmitter of the target device.
• Please also consult the instruction manual for the target device.
5 Maintaining the product
5.1. Changing the batteries
It is not possible to change the batteries for instrument types T1
and T2 (single-use data loggers).
A battery change stops a measurement that is currently
running. However, stored data is preserved.
1. Read out stored data.
2. Place the data logger on its front.
3. Open the battery compartment on the back of the data logger
by turning anti-clockwise. Use a coin for this purpose.
4. Take the spent battery out of the battery compartment.
5. Insert new batteries (see technical data for type required) into
the instrument so that the positive terminal is visible.
Only use new branded batteries. If a partially exhausted
battery is inserted, the battery capacity will not be
calculated correctly.
6. Place the battery compartment cover on the battery
compartment and close it by turning clockwise. Use a coin for
this purpose.
- The data logger is in reset mode, rSt is illuminated
(instruments with display), status LEDs are disabled.
7. Reconfigure the data logger, see the section Configuring the
data logger.
5.2. Cleaning the instrument
CAUTION
Damage to the sensor!
> Ensure that no liquid enters the inside of the housing.
> If the housing of the instrument is dirty, clean it with a damp
cloth.
Do not use any aggressive cleaning agents or solvents! Weak
household cleaning agents or soap suds can be used.
Shop for Data Logging products online at:
www.
DataLoggerStore
.com
1.888.610.7664