TIAH64D MPU-24
16
Section 4 – Post Operation
4.1 – General
Although the TIAH64D MPU-24 has been ruggedized and made weather resistant within the scope of unit’s
intended use, it is essential that good general care be taken to maintain unit in good operating condition and
to maximize unit’s operational life.
4.2 – After Use
Unit should be protected from environmental elements and man made hazards. Ideally unit should be secured
in a building or shed. Most importantly, unit shall be fully covered if stored while exposed to environmental
elements.
4.3 – Power Cell Recharge
The TIAH64D MPU-24 has an intelligent recharging system that will enable it to recharge when connected
to an AC power source. If the unit’s power cells become fully discharged, the unit should be recharged
within 24 hours to ensure maximum life and performance. Under normal circumstances a minimum of 143
minutes will be required to fully recharge the unit.
NOTE
!
Plug the TIAH64D MPU-24 into ac power to keep the cells charged whenever it is
not in use, even if it is at Full Charge. The unit will not overcharge or overheat.
Connect AC Power Cord to Unit
Ensure 120 or 240 Vac power cord is properly connected to an approved ac power supply. After approximately
5-8 seconds, ensure unit’s LED status indicator illuminates indicating power cell state of charge and cooling
fan is operating.
Figure 4.3.1 Connecting TIAH64D MPU-24 to AC Power Supply
