TI150 Series Battery Charger/Conditioner
16
5
Operating Procedures
1.
If the TI150 Battery Charger is already connected to the battery and hard
mounted to the vehicle:
Plug the ac line cord into the appropriate AC Source.
A.
Check to see that the LED shows that status of the charge.
B.
Check to see that the fan is running when the Battery Status LED is below
C.
100%.
2.
If the TI150 Battery Charger is not connected to the battery:
Disconnect the DC Quick Disconnect (QD) and remove the QD Cable As-
A.
sembly from the DC Output Cable Assembly.
Attach the either the QD Alligator Clips or Ring Terminals to the Battery.
B.
Positive connector first, then negative.
Plug in the ac line cord to the TI150 (if disconnected).
C.
Plug in the ac line cord to the appropriate AC source.
D.
Connect the DC Output QD.
E.
Check to see that the LED shows that status of the charge.
F.
Disconnecting the TI150 Battery Charger
1.
If the TI150 Battery Charger is hard mounted to the vehicle:
Disconnect the ac line cord from the ac source.
A.
Disconnect the ac line cord from the Battery Charger.
B.
Stow the ac line cord for later use.
C.
2.
If the TI150 Battery Charger is not hard mounted to the vehicle:
Disconnect the DC Output cable QD.
A.
Unplug the ac line cord from AC Source.
B.
Unplug the ac line cord from the TI150.
C.
Disconnect the Negative (Black) lead of the QD Alligator or Ring Terminal
D.
from the Battery.
Disconnect the Positive (Red) lead of the QD Alligator or Ring Terminal
E.
from the Battery.
Connecting the TI150 Battery Charger.
CAUTION
Failure to follow these steps in order can cause arcing
and or sparks.
Содержание TI15014-120-240
Страница 34: ......
