5
Remote control
does not work
(RC range is 5
meters)
Weak batteries in remote control.
Replace the batteries, observing
the correct polarity when
inserting them.
The vacuum cleaner is not
switched on or the battery is not
sufficiently charged to start
cleaning.
Make sure the vacuum cleaner is
turned on and recharge the
vacuum cleaner battery.
The infrared sensor on the remote
control is dirty or the infrared
sensor on the vacuum cleaner is
dirty.
Clean the remote control and
vacuum cleaner.
There is interference between the
remote control and the vacuum
cleaner.
Avoid using near other infrared
devices.
If this does not solve the problem, check that the battery is fully charged and then turn the vacuum
cleaner off and on using the „Main power switch“.
BATTERY CARE
In case of low battery detection during cleaning, the vacuum cleaner automatically searches the
charging station and starts charging
Keep the charging station switched on continuously, if it is not turned on, the vacuum cleaner
can not find it.
If you are carrying a robotic vacuum cleaner or you will not be using it for a long time, turn it off
with the main switch.
If you do not use the device for a long time, remove the batteries from the remote control.
The robotic vacuum cleaner is equipped with a high-capacity, modern Li-Ion battery, without
memory effect, so don't worry about multiple battery charging and discharging.
The vacuum cleaner is equipped with a special protection that stops supplying power after
charging and prevents overcharging, so the battery does not require frequent replacement.
In standby mode, the robotic vacuum cleaner consumes very little power, so we recommend that
you do not switch off the power supply. If you do not use the robotic vacuum cleaner for a long
time, switch it off and disconnect the charging station from the mains. However, you should fully
charge the vacuum cleaner every three months to prevent the battery from completely
discharging.
Содержание RoboStar iQ300
Страница 1: ...TESLA RoboStar iQ300 ...