Tesla MODEL 3 2020, Руководство пользователя

Страница: 34 / 271

WARNING: The head support in the
rear center seat must be lowered
when a seat belt retained child safety
seat is installed in that seating
position. See
Raising/Lowering the
Rear Center Head Support on page
32
.
WARNING: Ensure that all head
supports are positioned correctly
before sitting in, or operating, Model 3
to minimize the risk of severe injury or
death in the event of a collision.
Raising/Lowering the Rear Center
Head Support
To raise the head support, lift it until you hear
it click into place. Push down on the head
support to ensure that it is secure.
To lower the head support, press and hold the
button on the outer base of the right post
and press the head support down.
Removing/Installing a Head
Support
To remove the head support:
1. Raise the head support as described
above.
2. Press and hold the button on the outer
base of the right post.
3. Insert a short, flat object (such as a small
flat-head screwdriver) into the opening on
the inside base of the left post and pull the
head support upward.
To re-install the head support:
1. With the front of the head support facing
forward, insert both posts into the
corresponding holes on the seat back.
2. Press down on the head support until it
clicks into place.
3. Pull up on the head support to ensure
that it is secure.
WARNING: Ensure that the head
support is correctly installed before
seating an occupant. Failure to do
so increases the risk of injury or
death if a collision occurs.
Seat Heaters
The front and rear seats contain heating pads
that operate at three levels from 3 (highest)
to 1 (lowest). To operate the seat heaters, see
Climate Controls on page 154 .
Front and Rear Seats
32 MODEL 3 OWNER'S MANUAL