Qg 2 Multi-Sync Gateway User Guide
Introduction
SJC-DEV7250-HR Rev. 1.14
8
Figure 3 The Ts2 Rear Panel
Rear Panel Description
Ground connector
Primary power plug, 34 – 60 VDC / 28 – 40 VAC
Secondary power plug, 34 – 60 VDC / 28 – 40 VAC
Table 1 Ts2 Rear Panel Interfaces
1.3
Typical Applications
Ts2 is a small form factor IEEE-1588-2008 PTP Edge Grand Master and Boundary Clock that can be used
for smart grid transmission and distribution substations. This Multi-Sync Gateway platform is designed
for small cell clusters, C-RAN, and edge applications. For more information about PTP, see [1].
1.4
Oscillator Options
Standard:
OCXO oscillator, 4-hour holdover for 1.5 µsec accuracy.
Superior:
Super OCXO oscillator, 8-hour holdover for 1.5 µsec accuracy.
1.5
PTP Slave Capacity
The Ts2 has variants that can support different unicast slave capacity (32, 128, 256, ..) slaves at up to
128 sync / delay packets per second when the MCE is operated as a master clock depending on the
product SKU. The variants are configured at the factory and cannot be field upgraded at present.
Contact information for ordering the Ts2 with the supportable slave capacities is presented in the
Contact Section of this User Guide on page 44. Section 8 of this User Guide presents all the variants
available.
1.6
Components Block Diagram
The following block diagram defines the main components of the Ts2 system along with the physical
connections to each component.
