Tescom TMV1500SEA, Инструкция по эксплуатации

Страница: 4 / 32

3 28
When the Ingredient check lamp is lit
When the Power button lamp is lit
Handling method Probable causes
Precautions
After you used the product or when performing
maintenance, please be sure to shut the power
OFF and pull the power plug itself out from the
outlet.
Otherwise, injury may result.
Please do not touch the
cutter, as it is very sharp.
Otherwise, injury
may result.
Please hold the power plug itself when you pull
the cord out from the outlet.
Otherwise, damage to the power plug may result.
Please plug and unplug the power
cord only after confirming that the power is OFF.
Otherwise, injury may result.
Please do not place your
finger or a metal spoon, etc.,
in the blender container.
Doing so may cause
an injury or a failure
in the device.
Please ensure proper care of the cap after
every use of the product.
(Please see pp.23–26.)
Otherwise, product failure may result.
Please do not push the vacuumizing arm from
above when the container unit does not have
the cap in place.
Doing so may
cause failure or
an accident.
Please never directly push the safety switch or
the safety switch
pin with your finger,
a rod, etc.
Doing so may
cause injury
or failure.
Please do not use the unit
at a place that is unstable.
Doing so may cause
an injury or the
breakage of the
product.
Please do not move
the unit during operation.
Doing so may
cause injury.
About error notification
When the motor is overloaded, the Ingredient check lamp becomes lit.
After transferring the contents of the blender container to another
container, please handle it as below.
As the safety device of the motor is in operation, please allow the unit to rest for more than 30 minutes.
* When you process the ingredients again using the vacuum
blending function, please do so after paying attention to the cover.
There may be ingredients or
bubbles inside the blender cover
cap.
The product
stopped operation
when
decompressing the
container interior.
The product
stopped operation
after the cutter
started to rotate.
Please take good care of the cover and wipe
off any moisture carefully. (Please see p.25.)
Please remove any bubbles inside the
container.
Are you using any hard-to-blend
ingredients (due to overly large
size), or is the liquid dilution too
low, etc.?
Please cut the ingredients into smaller
pieces.
Please add liquid, such as water.
Are you using too many
ingredients?
Please reduce the ingredients used and
comply with the operating capacity of the
blender container. (Please see p.12.)
Are you using ingredients that
are actually unusable?
Please remove any unusable ingredients.
(Please see p.11.)
Are there ingredients stuck
between the cutter parts?
Please dismount the blender container from
the container base (please see p.24) and
remove the stuck matter using a long
slender utensil, etc.
3
Dismount each container
unit from the main body.
(Please see p.15 and p.21.)
4
Check the probable causes below and handle the unit responding to the
causes shown.
Caution
Be sure to
comply
Prohibition
Pulling out
the power
plug
Prohibition
* When the problem cannot be fixed nevertheless, please contact the address or phone number shown
on the fancy box, or contact Tescom Co., Ltd. directly (contact info shown on the back cover).