TRC13
EN
5
CHARGING
Before using the appliance charger, ensure that the
voltage of your electricity supply is the same as that
indicated on the charger.
Your clippers contain re-chargeable batteries and
may be used cordless for approximately 45 minutes
when the batteries are fully charged.
IMPORTANT NOTE: The batteries must be charged
for a minimum of 12 hours for the first charge cycle.
This will ensure the maximum life for the batteries.
Assembling the charging stand
Before using the charger for the first time you will
need to assemble the charger and stand.
Charging the clippers
Dock the clippers onto the stand.
1.
Open the latch under the
1.
stand as shown.
Plug the Charger into the
2.
mains and switch on at
the outlet.
The
Power/charging
3.
indicator on the Clippers
will flash red.
Leave the Clippers on the
4.
stand until fully charged
(approximately 12 hours
if the batteries were fully
discharged).
After charging, disconnect the Charger from the
5.
mains to conserve power and store it in a safe
place.
The Clippers are now ready for use.
6.
Press the charger plug into
2.
the opening in the stand.
Close the latch to secure the
3.
plug.
Lead the wire out through
4.
the slot in the back of the
stand.
The stand is now ready for use.
