TESA TESA-Rugosurf 20, Инструкция по эксплуатации

Страница: 9 / 24

9
8 PROBE
Your Rugosurf 20 incorporates a translation
mechanism with the probe attached by means
of the height articulated probe-holder. In order
to swap the probe, simply pull it in its axis op-
posite to its displacement. For attachment, the
probe is just plugged in.
The measurements can be taken by lying down
the gauge unit on the surface to be checked.
But, you may also mount it on a support or use
its protection to rest it on the relevant surface.
Other supports can additionally be made avail-
able, rendering all measurement operations
easier.
When inspecting cylinders, use the auxiliary
supports that came with the roughness gauge.
Note
The probe comes with a built-in inductive meas-
uring system. Should this feature be swapped,
or important changes in the ambient conditions
occur, a calibration as described in chapter 10.4
will then be required.
For checking purposes, it is advisable to regu-
larly carry out a measurement on the standard
contained in the delivery scope.
Special parts or hard-to-reach locations can be
measured with the Rugosurf 20 clamped to the
standard support using the 8 mm diameter fix-
ing rod provided with the gauge. The latter will
be screwed into the convenient thread located
on the lower face of the gauge.
The two extra V-shaped supports allow for any
cylinder up to 80 mm in diameter to be meas-
ured. They will need to be attached on both front
and rear gauge faces.