TES MicroTouch OF-195P-A1, Руководство пользователя

Страница: 24 / 37

24
Bracket Mounting
The included MicroTouch bracket kit OF-BRKT-22B can be used to flush-mount the monitor in a
panel. The kit includes four smaller monitor brackets and four larger slotted panel-mount
brackets. Two of the smaller brackets are mounted to the sides of the monitor and the other
two of the smaller brackets are mounted to the top and bottom of the monitor using eight of
the sixteen included screws. The pre-tapped M4 holes are on the back edges of the
monitor.
The four larger slotted brackets are then mounted to the rear of the panel, at the sides and at
the top and bottom of the opening. The monitor is then pushed into the opening from the front,
compressing the tapered foam surrounding gasket, and each bracket pair is joined from the
rear using the remaining eight screws included in the bracket kit. Slots in the panel-mounted
brackets allow adjustment to slide the monitor into position flush with the front of the panel
and the screws are then tightened to secure the monitor in place.
The monitor may be mounted into a panel in any of three ways:
1.
incorporating pressed-in threaded studs (PEM® studs) in the back of the panel
2.
if the panel is sufficiently thick, M4 threaded holes may be incorporated
3.
clearance holes for M4 screws may be used
The methods use different hole spacings, as detailed in the drawings on the following page.
Note that, because of the bezel-less design, the screw locations are outside the panel opening.
If the fasteners are to be invisible, either the pressed-in stud or threaded hole method should
be used. Flat head (flush with panel) screws may be used to improve the appearance i f thru-
hole screws are to be used.