Terumo BCT T-RAC II, Инструкция по эксплуатации

Страница: 136 / 146

Page 66 of 76
[WARNING] Do not use a moist cloth to clean the electrical contacts for the battery and do
not spill any liquid on these contacts. This can create short circuits and damage the battery
irreversibly.
10.2 Preventive maintenance
10.2.1 Check of the weighing function
Terumo BCT recommends to check the weighing function of the device weekly or every
time the device is moved (e.g. for mobile collection). This can be done by:
1. Switching on T-RAC II until the idle state is reached (see chapter 6.2).
2. Pressing the ‘TARE’ button on the touch screen.
3. Placing a calibrated weight of minimum 200g and maximum 500g on the tray
and checking its weight. The maximum allowable deviation from the weight is
±3g. If this is not the case, please have your T-RAC II device serviced.
10.2.2 Check of the alarm function
Regularly check the alarm function in following way:
1. Go to the settings menu and make sure that the program setting ‘All alarms
aud.’ is set to ‘Yes’. Refer to chapter
7 for more information.
2. Switch-off T-RAC II by pressing the on/off button and holding 3 seconds.
3. Pull-out the battery and make sure T-RAC II is still connected to the mains.
4. Switch-on T-RAC II by pressing the on/off button.
5. An alarm should sound and the antenna LED should be illuminated.
10.2.3 General maintenance
To assure safe and trouble free operation, please have your T-RAC II serviced at least
every 12 months, depending on the frequency of use. If you experience a system
failure, please call Terumo BCT or your Terumo BCT representative for servicing. When
calling for servicing, please be able to describe the problem and have the serial number
available so that faster handling of the repair will be possible. Do not attempt to
dismantle or repair the unit. Only qualified personnel are authorized to service the
machine.