Terumo BCT T-RAC II, Инструкция по эксплуатации

Страница: 111 / 146

Page 41 of 76
[NOTE] It is best to put this event as early as possible in the program flow. By
switching to another program, the program flow will change as well.
[NOTE] When this event is shown at startup of the device, the chosen program will be
the default program for all donations until the device is restarted.
[NOTE] Results from events preceding a ‘Program #’, won’t be saved into the donation
statistics if another program was selected.
8. Weight check
Some donation center’s procedures request a confirmation of the balance’s calibration.
This event doesn’t calibrate the scale but offers a means of validation. When the event
is shown, the user needs to place a 200g weight in the tray. If the 200g (±3g) is
correctly weighed during 2 seconds, the event will proceed automatically to the next
event. Otherwise, the scale needs calibration. Contact Terumo BCT for this service. It
is not possible to skip this event unless it occurs after donation.
Weight currently measured
[NOTE] Only qualified Terumo personnel are authorized to do the calibration of the
scale. Normally, no calibration will be needed during the life time of T-RAC II.
7 Settings
In order to offer maximum flexibility, the configuration of T-RAC II is divided in a number of
setting types. The device settings
and the communication settings are inherent to each device
and need to be configured separately on each T-RAC II device. The programs, which contain
most settings, are interchangeable with other T-RAC II de vice s and with TOMEs. This can be
done via a TOMEs network (chapter 5.10) or via a USB flash drive (chapter 7.2). Some parts
of the programs can only be configured on TOMEs.
On T-RAC II Jr, there is only 1 program available which cannot be exchanged with other
devices.