TERSO TS087, Руководство пользователя

Страница: 14 / 16

14 TS087 User Manual
DO DON’T
DO check if the application surface is clean and dry DO NOT ever bend or crease the tag
DO ensure there are no wrinkles in the tag after
application
DO NOT place tag directly on a container with liquid
DO try to keep all tags aligned in the same
orientation
DO NOT apply tags to a curved surface with a diameter smaller
than 3”
DO try to keep all tags aligned in the same
orientation
DO NOT place tag on or near any metal surface or any packaging
containing metal unless it is an ‘On-Metal’ tag
DO prevent tags from contacting each other when
stocked
5-95% non-condensing
DO allow for some separation between tag - ideally
> 1”
DO NOT remove and reuse a tag once applied
Dimension of items
Tags should be placed on a product that allows the entire tag and adhesive to be adhered to the
product. Do not allow the tag to overhang over an edge.
Available space is available on the product for applying a tag on a flat surface
Stocking orientation requirements may be necessary. Consider the direction in which the tag will
be read.
APPENDIX C: MOUNTING GUIDELINES
Mounting and Deployment Success Factors
A successful Device deployment requires users to understand a range of external factors
that can constrain the use case details and success criteria requirements, including but not
limited to: the physical environment, RFID tag constraints, RFID tag read sensitivity, Device
mounting variations, and configuration settings.
Generally, most deployments require some detailed testing of use cases to ensure the
required outcome is possible within the customer’s typical RF environment.
Terso’s preferred mounting location is on a ceiling near the opening of the entrance or exit to
a specific area.
At a minimum, the following should be considered:
• Verify the model is correct model for the geographical region - US, ETSI (Europe), etc.
• Identify the RFID tag type and performance to ensure the item being tagged can be
read by the Device. (i.e. On-metal tag, tag orientation, tag size, tag sensitivity, item
material)
• Tags with Impinj Monza R6 chips using inlays of at least 70mm long is recommended.
The Monza R6 chip has the best and most consistent read ranges
• Consider the likely area coverage for planning where to install your Device for success
• The Device is designed for installation at heights ranging from 8ft to 15ft. However,
lower ceilings may be used. A typical 8 foot ceiling will have a smaller read area and
may require specific positioning based on the location.
• When deciding on the placement the Device, don’t base placement decisions on the
furniture, racks, cabinets, or other large objects below especially if the positions are
subject to change.
• Install the Device at or below the level of HVAC equipment, pipes, and especially
fluorescent lighting.