Page 13 of 20
NOTE: If you are performing performance testing, and wish to record an accurate
maximum speed it is best to clear the memory before the testing takes place.
11.2 0-60 times:
11.3 0-100 times:
11.4 0-(custom) times:
0-60, 0-100 or 0-custom (kph or mph depending on units set) is recorded in all modes
of operation. The unit starts recording time when the vehicle moves away from
standstill, and stops recording acceleration when the vehicle achieves the target speed.
Once the unit has recorded the acceleration time, it waits for the speed to drop below
the target speed, and then to reach zero during which time the unit is recording
deceleration time.
If at any time during the acceleration the speed returns to zero, the 303 will reset the
timer and not record a time, as the vehicle did not achieve the target speed.
Once all 8 memories are full, the unit will not record any more performance times
until the memories are erased.
There are 8 memories each for 0-60 times, 0-100 times, and 0-custom times.
To clear the stored memories press upper
CLR
whilst 0-60 times, 0-100 times or 0-
custom is highlighted, and this will clear the stored times selected.
Press
ENTER
when any of the performance time menu items are highlighted (e.g. ‘0-
60 Times’), and you can view the saved performance times. The time and date of the
record is shown as well as the times recorded for acceleration and deceleration. Use
the up and down keys to look through the stored records.
Press
MENU
to return to the performance menu.
Press
ENTER
whilst 0-60 times, 0-100 times or 0-custom time results are being
displayed and the 303 will go into live performance measuring mode. The screen will
display the current speed, acceleration time, and deceleration time. At standstill the
speed will be highlighted, and once the vehicle moves away from zero, the highlight
will move to the acceleration time. Once the target speed is reached, the highlight will
return to the speed.
As soon as the speed drops below the target speed, the highlight will move to the
deceleration time, and stay there until the vehicle comes to a standstill.
Once a valid time has been recorded the screen will show the record that has just been
created.
At any time pressing
ENTER
will return to the records,
0-(custom) times only
To set the custom speed for 0-(custom) time performance – Highlight ‘0- (custom)
times’ line in the performance menu, then press the down arrow. This will highlight
only the speed rather than the whole line. Press
ENTER
, and set the speed with the