Terratek TPMT15VBE, Руководство пользователя

Страница: 10 / 15

26. NEVER LEAVE TOOL RUNNING UNATTENDED. Turn power off. Don’t leave tool until it
comes to a complete stop.
27. Double Insulation eliminates the need for the three wire grounded power cord and grounded
power supply system.
This power tool is supplied with all the relevant safety guards and features, it should be
checked before every operation, this manual should be read and kept in a safe place. Whilst
we warn of all the possible risks attached to using power tools any operator must have read
and understood the manual and apply their own caution and common sense when using this
power tool.
Following this guide will greatly reduce your risk of electric shock or injury.
Only use qualified repair agents to service this power tool.
Only use qualified electrician to repair any damaged wiring.
NEVER remove the grounding prong from the power tool or extension cord.
Power Extension Cords
When using any extension cord the machine will suffer a power reduction due to the drop in
voltage caused by the length of the cord. This can be partially offset by selecting extension cords
with lower gauge wire.
Check all extension cords for damage before use.
Avoid sharp objects.
Do not position the cord where it could be subject to traffic passing over it.
Symbols
IMPORTANT: Some of the following symbols may be used on your tool.
V…………………………volts
A…………………………amperes
Hz……………………….hertz
~………………………..alternating current
…/m……………….revolutions per minute
.........................
class II construction (double insulated)
Kg……………………….kilograms
n0……………………….No load speed
……………………….Conforms to European safety standards
…………………
Direct Current
Additional safety rules for Oscillating Tools
WARNING: Always wear eye protection.
Hold power tools by insulated gripping surfaces when performing an operation where
the cutting tools may contact hidden wiring. Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the operator. Do not drill, fasten or break into existing walls
or other blind areas where electrical wiring may exist. If this situation is unavoidable, disconnect all
fuses or circuit breakers feeding this worksite.
Use a metal detector to determine if there are gas or water pipes hidden in the work area
or call the local utility company for assistance before beginning the operation.
Striking or cutting into a gas line will result in explosion. Water entering an electrical device may
cause electrocution.
Always hold the tool firmly with both hands for maximum control. Keep proper footing