Terratek TMCS01, Руководство пользователя

Страница: 8 / 14

3. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
4. ALWAYS REMAIN ALERT WHEN THE TOOL IS IN USE. Inattention on the part of the operator may
lead to serious injury.
5.
DON’T USE IN A DANGEROUS ENVIRONMENT. Don’t use power tools in damp or wet locations or
expose them to rain. Keep work area well lit.
6.
KEEP CHILDREN AWAY. All visitors should remain at a safe distance from work area.
7. MAKE WORKSHOP CHILD-PROOF with padlocks, master switches or by removing starter keys.
8. USE THE RIGHT TOOL. Don’t force a tool or attachment to do a job for which it was not designed.
9. USE THE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using
an extension cord, be sure to use one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage resulting in loss of power and overheating. If in doubt, use
the next heavier gauge. The smaller the gauge number, the heavier the cord.
10.
DON’T FORCE THE TOOL. It has been designed to operate at maximum safety and performance levels.
11. DO NOT FORCE THE MATERIAL BEING CUT. Always let the tool cut at its own speed.
12. WEAR PROPER APPAREL. Do not wear loose clothing, neckties, rings, bracelets or other jewelry which
may get caught in moving parts. Non-slip foot wear is recommended. Wear protective hair covering if you
have long hair.
13.
ALWAYS USE SAFETY GLASSES. Also use face or dust mask for commercial cutting operations.
Everyday eyeglasses only have impact-resistant lenses, they are NOT safety glasses.
14.
SECURE WORK. Use clamps or a vise instead of your hand to hold work when practical. This safety
precaution allows for proper tool operation using both hands.
15.
DON’T OVERREACH. Keep proper footing and balance at all times.
16. MAINTAIN TOOLS WITH CARE. Keep tools clean and in good working condition for maximum safety
performance. Follow instructions for lubricating and changing accessories.
17.
DISCONNECT TOOLS BEFORE SERVICING – when changing accessories, such as blades, bits, cutters,
etc.
18.
REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in OFF position before
plugging in.
19.
USE RECOMMENDED ACCESSORIES. Consult the owner’s manual for recommended accessories. The
use of improper accessories may increase risk of injury.
20.
MAKE SURE YOU USE THE CORRECT TOOL for the job you are doing.
21. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
22.
CHECK DAMAGED PARTS. Before further use of the tool, damaged part(s), (i.e., guard) should be
carefully checked to determine that it will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other condition
that may affect the tools operation. A guard or other part that is damaged should be properly repaired or
replaced.
23.
DO NOT ALTER THE PLUG.
24. NEVER LEAVE TOOL RUNNING UNATTENDED. Turn power off. Don’t leave tool until it comes to a
complete stop.
25.
Double Insulation eliminates the need for the three wire grounded power cord and grounded power
supply system.
This power tool is supplied with all the relevant safety guards and features, it should be checked
before every operation, and this manual should be read and kept in a safe place. Whilst we warn of all
the possible risks attached to using power tools any operator must have read and understood the
manual and apply their own caution and common sense when using this power tool.
Following this guide will greatly reduce your risk of electric shock or injury.
Only use qualified repair agents to service this power tool.
Only use qualified electrician to repair any damaged wiring.
NEVER remove the grounding prong from the power tool or extension cord.