20
We ACL Group (Intl.) Ltd, England DN6 8LZ declare that the rotary hammer drill has been
manufactured according to our full quality assurance procedures.
The declaration is to certify that it conforms to CE, EMC, MD and RoHS directives:
EN55014-1/A1:2009
EN55014-2/A2:2008
All provisions of Annex 1 of Council Directive 2004/108/EC – EMC directive
EN60745-1/A11: 2010
EN60745-2-6: 2010
All provisions of Annex 1 of Council Directive 2006/42/EC – Machinery Directive
RoHs 2011/65/EU
Accessories
CAUTION: Use only accessories or attachments recommended for use with your Terratek tool
specified in this manual. The use of any other accessories or attachments might present a risk
of injury to persons. Only use accessory or attachment for its stated purpose.
General Maintenance
1. Keep the air vents free from obstruction and clean regularly.
2. Check regularly for any dust particles entering the grills around the motor and the switch.
Use a soft brush to remove any dust particles. Wear safety glasses to protect your eyes whilst
cleaning.
3. Monitor the dust bag (if equipped) and empty when approximately half full. Always empty
into an appropriate container. REMEMBER: dust can be hot and cause fire.
4. If the cutting tool has become dull, replace it. Dull cutters will cause increased tear-out and
ragged edges on the cuts.
5. Lubricate all moving parts at regular intervals.
6. To clean the body of the power tool, only use a soft damp cloth. Do NOT immerse in water.
A mild detergent can be used but NOT petrol or any alcohol based product.
7. Should the power cord become damaged only allow a fully qualified electrician to replace
or repair.
