Edit mode: NORM
A parameter will respond to both incoming controller data as well as manual changes to
the controls. For example, changing the Cutoff control will set the cutoff frequency to the
value corresponding to the control's position. Receiving controller data with the number
103 will also set the cutoff frequency to the value specified in the controller data.
Edit mode: MOVE
In this operating mode, controller sequences can be moved up or down using the
appropriate manual control, i.e. a value corresponding to the position of the manual
control (MOVE value) will be added or subtracted from the received controller values.
Example: changing the controller sequence for the cutoff frequency
n
n
n
Connect the MIDI OUT of the SINE MB 33 II to the MIDI IN of the MIDI recording
device (e.g. computer, hardware sequencer, etc.) and the MIDI IN of the SINE MB 33
II to the MIDI OUT of the recording device. Start the sequencer so that it sends a
melody and a controller sequence with cutoff frequency data to the SINE MB 33 II.
Set the EDIT MODE switch to MOVE.
To change the controller sequence for the cutoff frequency, the cutoff control must be
at least in the middle position. In this position the original controllers will remain
unchanged. Turning the cutoff control clockwise will now increase the MOVE value
(up to a maximum of 64). The MOVE value will be added to each received controller
value. Turning the cutoff control to the left will also cause the MOVE value to increase
(up to a maximum of 64). This MOVE value will be subtracted from every received
controller value, however. The controller sequence modified in this manner is
continuously sent to MIDI OUT, even if the cutoff control is not changed further.
n
Recording the modified controller sequence at the MIDI recording device.
SINE MB 33 II (English)
15
