7
2
Montaje en DIN rail
Figura 6. Montar o desmontar del/al DIN rail
del separador de plastico (suministrado).
Figura 4. Montaje al DIN rail
Figura 5. Desmontaje del DIN rail
Installation instructions
Read the safety instruction first.
If any of RF connectors are not used, connect 75
Ω
isolated load.
Operating
Turn on the regulators clockwise with supplied plastic screw driver to increase gain for each sub-band (figure 1, pos. 2).
The powering circuit has overload and short circuit protection.
If external equipment total current consumption is ≤ 0.1 A, status indicator (4) glows green.
When the current is higher than this limit, the protection circuit starts to operate and the power feeding is being disconnected
from external equipment. In this case status indicator (4) glows red.
Mounting
The module
or mounting bracket must be fixed with steel screws Ø 3.5-4 mm. The screws are not included in a package.
Mounting on a wall by screws
Mounting on a bracket (supplied)
Connection of cables
Perpendicular to the wall
Parallel to the wall
Figure 2. Mounting of the amplifier
Figure 3. Powering of the amplifiers
UP410S
- power supply
