In order to provide for the safety of the boiler and the assembly in case of power outages,
the installation should have a by-pass line.
Make sure to use a suitable check valve for all solid-fuel boilers and the pressure of the
check valve should be equal to the maximum operating pressure of the boiler. On boilers
operating with 3 bar working pressure 3-bar safety valves should be used.
In regions prone to risk of freezing, expansion tank and insulation should be used.
The diameter of the shaft should not be smaller than the output diameter of the boiler shaft
and the instructions on the shaft assembly specified in this manual should be followed.
Expansion tank flow and return pipes should be installed with continuous upward
inclination from the boiler to the tank without any downward bending.
4
The boiler should be connected to the chimney of the building without narrowing the
diameter at the flue outlet and through pipes having minimum the same or larger diameter at
the flue outlet and through pipes having minimum the same or larger diameter as the boiler
flue outlet.
For installation of the boiler warning points indicated in the user manual must be
taken into consideration. The supplier will not take any responsibility for wrong
installation of the boiler and chimney.
During the installation of the appliance, make sure to leave some space around the
appliance depending on the properties of the appliance enough for the technical service to
handle the appliance.
Make sure the location where the appliance and the waste gas disposal line are situated is
not a living space.
In order to minimize the heat loss, the installation pipes should be heat-insulated.
Connectors and valves should be placed on inlet and outlet lines.
HEATING SYSTEMS
