CLEANING AND MAINTENANCE
Annual periodic maintenance must be performed by AUTHORIZED SERVICES OF
TERMODİNAMİK to ensure the boiler and all components operate efficiently and
safely.
When Cleaning:
The main power supply should be turned off.
The power of the circulation pump should be cut off.
Turn off the gas valve (fuel line).
Make sure that the boiler surfaces are not hot.
Open the front lid of the boiler. Take out the turbulators and clean them.
Clean the burning chamber and the pipes’ inner surfaces with the pipe brush.
Check the front and rear sealing components.
Place the turbulators back in after cleaning.
Turn on the fuel line.
Turn on the main power supply.
When the Burner Indicates Malfunctioning, Before Calling the Authorized Service,
Ensure:
The system is able to receive power,
Minimum gas pressure is available,
Fuel valves are on,
The system’s water level and the pressure are at normal levels.
If the system operates using liquid fuel, the boiler heat transfer surfaces should be cleaned at
least once a month. This duration may be shorterand the cleaning frequency may increase
depending on the factors like the quality of the fuel used, accuracy of the burning adjustment
done and shaft draft.
Have the AUTHORIZED SERVICES OF TERMODINAMIK perform the controls
specified in the maintenance instructions on the next page. This is critical to ensure both
a safe and efficient operation of the boiler and your life safety.